chanelink logo
CHANELINK
English

Serial USB Conection Problem

Categories:
Laser
Tags:
189
1
See translation
2023-03-20

Hello guys, I have problems with disconnections.
I made a small, fine laser that I want to control via USB with an Arduino Uno clone and a CNC Shield V3.
I have the problem that my laser keeps refusing to do its job.
Regardless of whether I try it with LaserGRBL or with LightBurn, the machine always stops in the middle of the process.
I’ve tried several different cables, several UNO’s, changed the buffer settings and finally grounded all metal parts of the part.
In Lightburn, I’ve now noticed that when such a termination occurs, either an “o” or a “k” is displayed in the console.
Unfortunately, I didn’t get any further with searches, maybe someone here had a similar problem before.

LightBurn V 1.3.01
Arduino Uno GRBL 1.1
CNC Shield V3
USB Serial

C

    • Patrick

      2023-03-21
      Had the same issue but solved it, the cheapest solution was to put the power supply on its own circuit from all other on/off appliances in the house.
Had the same problem random disconnects, drove me crazy tried all sorts, in the end I found it was the Freezer, on same mains ring, every time it turned on or off it browned the board out, put it on a different mains ring and all is good, I did until I solved the problem use a inline home made UPS , but i just used an inverter off a car battery on a permanent digital charger. to run the machine, can buy a pre made one on amazon from about £50 upwards depending on the power demand, as it being supplied through a constantly charged battery via an inverter, its isolated form any spikes, in the house main power rings.
When the Freezer was causing the issue the compressor would kill the connection when it turned off and on as well as the extractor fan, now all seems to be ok with the freezer on a different loop.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report