Is there any way that we can specify that one of the layers (in my case it is the Red 02 - Boundary Cut layer) always be last in the cut order, regardless of how the ordering is set on import, last used settings etc?
I’ve been bitten a few times where I hadn’t noticed another layer is below this, and ended up with inner cuts or engraves in different layers being after the cut, and the pieces end up dropping (if I don’t catch it) and the focus is messed up (or worse, the piece is ruined because it dropped on an angle).
No, I don’t believe there’s any way to do what you’re describing.
You could potentially enable a checklist in Edit->Device Settings and set a reminder to check your layer order if it’s a recurring problem.