Move Location On Import
Categories:
Laser
311
1
0
2023-03-30
C
Abel
2023-03-31I don’t believe so. There are 2 different import placement behaviors that I’m aware of: 1. If you do File->Import the design will load in the center of your workspace 2. If you drag-n-drop to the workspace the design will open where you release the mouse Not sure if either of these could help you.
0Reply
Relevant recommendations
- 2022-09-01
- 2023-08-30
-
Show exact cut without cutting
1 Reply2023-10-07 - 2022-12-24
-
Dedicated circuit sizing
1 Reply2023-07-25