Pictures burning crooked
Categories:
Laser
176
1
0
2023-04-10
My laser is engraving pictures crooked. I have checked to make sure the OLM 3 frame is square and it is. I squared the plywood to the front of the machine. I measured the distance of the gantry to the front of the frame and it is the same. I have tried rotating the image and the plywood as you can see in the pictures. Any ideas what is going on?
C
Smith
2023-04-11Are you running in inches? If so, this is a known firmware issue with the Ortur, and solved with a recent update.
0Reply
Relevant recommendations
- 2022-08-18
-
Eading point of job
1 Reply2023-06-20 - 2022-09-22
