chanelink logo
CHANELINK
English

Print and cut problem

Categories:
Laser
Tags:
109
1
See translation
2023-05-13

Hello comrades, I am cutting stickers using the “print and cut” function and I follow the instructions to the letter, but when cutting, the figure does not fit me perfectly and in some cases it looks bad, I occupy “target position” Diagonally shaped marks (one from the top left and one from the bottom right for example).
What strikes me is that some figures are quite good and others very bad.
What am I doing wrong?
how could i solve this?
Any advice or improvement?
Thank you

C

    • roy

      2023-05-15
      A few things to review:

1. The print looks like it’s curled. When you print, make sure that it’s perfectly flat.
2. Did you use scaled or unscaled target alignment? If the print is printed to scale and you’re working from the same design for both then use unscaled, otherwise use scaled.
3. Make sure that the print is indeed printed to the scale that you expect. Measure the distance corner to corner between registration marks. Compare that with the measured distance in LightBurn.
4. Confirm that your laser is calibrated for accurate distances. Make a 200x200 square in LightBurn and burn to a known flat surface. Measure the resulting burn. Does it match? If not, use Edit->Machine Settings->Calibrate Axis to adjust.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report