Double line cutting on atomstack M100 / E85 module
Categories:
Laser
261
1
0
2023-05-24
Hello everyone, I am having a double-line issue. I have already adjusted both axis, but the problem persists.-
What i find strange is that all the double lines go in the same way, and they al seem perfectly cut and seems like a pattern and not linke an error.
Any advises? Is it a harware issue?
Thank you all in advance.
C
Keegan
2023-05-25How have you done this? To me it looks like you may be missing steps on the X-axis. Check belt tension and make sure you’re not skipping the belt. Also check that the pinion gear is properly secured to the stepper shaft.
0Reply
Relevant recommendations
- 2023-06-20
- 2022-09-01
- 2022-11-01
- 2023-04-04
- 2022-11-14
