Start Position Not Right
Categories:
Laser
256
1
0
2023-06-09
C
Payson
2023-06-10You almost certainly have an unaccounted for shape elsewhere on the workspace. This is likely going to be from one of your other layers that are not being shown. Keep in mind that all layers are factored in for job origin. If you only want the selected shapes to be considered for origin then enable both “Cut selected graphics” and “Use selection origin”.
0Reply
Relevant recommendations
-
Error 20 et 1 plus de gravure
1 Reply2023-05-31 -
How do i draw a one inch circle?
1 Reply2023-02-28 - 2023-06-07
- 2023-06-01