Dirt in the cut
Categories:
Laser
211
1
0
2023-06-19
do you know why when you cut in one direction (green arrow) it doesn’t get dirty and when you go back (red arrow) it gets dirty?
C
Abel
2023-06-20The laser will traverse the red path in both directions unless: Optimize Cut Path is turned on Remove Overlapping Lines is turned on The lines overlap within the tolerance distance If your “larger” laser is a CO₂ (typical for a Ruida controller) and the material shifts slightly after the complete perimeter cut, then it’s charring the edge of the shifted material.
0Reply
Relevant recommendations
-
Maching lines within tow images
1 Reply2023-05-30 -
Over Burning Edges
1 Reply2023-09-12 - 2023-09-27
-
Connect XTOOL D1 PRO
1 Reply2023-06-13 - 2023-04-26
