Placement of circle from a corner
Categories:
Laser
429
1
0
2023-07-04
C
Miller
2023-07-05Not sure this is easier, but if you “Offset Shapes” inward .25 of an inch + the radius of the circle needed, on the outer border of your wall plaque, then make sure it is centered up-down and left-right. Then you have a corner to place a circle’s center of the desired size correctly on the corner of the inner shape. Hope this helps.
0Reply
Relevant recommendations
- 2024-01-29
-
Sculpfun s9 Mirrored Print out
1 Reply2023-03-07 -
Array Tool and Tabs
1 Reply2023-05-29 - 2023-07-08