Setting Starting Point
Categories:
Laser
254
1
0
2023-07-05
I’d like to cut out these two tree shapes using a perforated cut. I want to hide the “skip” spots under the tree branches where they are not so visible, since they stand out against the charring of the rest of the perimeter cut.
How do I specify the starting point so I can set a distance that places the “skip” spots where I want them?
C
Robert Evans
2023-07-06LightBurn has a Tabs and Bridges tool built into the Cuts Settings Editor. You want manual control of where the line is not engraved? Select Manual under Tab Generation.
0Reply
Relevant recommendations
-
Application fields of ultraviolet laser
0 Replies2024-12-02 - 2022-10-08
- 2023-06-01
- 2022-10-12
