Multi setting in lightburn
Categories:
Laser
321
1
0
2023-07-05
I bought a file on Etsy, when I import it into lightburn I get the following setting (see photo) how do I set this properly so that the laser will engrave and cut
Greetings Ronald
C
Robert Evans
2023-07-06Double Click on the entry in the Cuts/Layers Section, and it will bring up the Cut Settings Editor. This will show the different layers within the Multi layer as seen here: Select each part to edit the attached settings.
0Reply
Relevant recommendations
- 2023-09-07
-
Cut/Layer, Text without 'Fill'
2 Replies02-14 - 2022-12-10
-
Rotary engraving oversize
2 Replies2023-08-17
