Welds with a negative effect
Categories:
Laser
279
1
0
2023-07-06
Hi, sstruggling with making this simple clock face. searched for info and says normally caused by open shapes but thee are just humble rectangles, any help much valued.
C
Darren
2023-07-07First group the two circles that make-up the outside of the face. Then try welding again. Also, not that the rectangle at the 10 o’clock position seems to be rotated incorrectly.
0Reply
Relevant recommendations
-
Connect the laser to a USB hub
1 Reply2023-06-05 - 01-13
-
M3 Nano Lightburn Supported?
1 Reply2023-04-15
