Engrave Settings, Suggestions?
Categories:
Laser
241
1
0
2023-08-01
C
John Trant
2023-08-02I see you’re dithering, which is a great approach for these. A couple of things to try… Let’s get the dark, darker… :slight_smile: If you dissolve some baking soda into water and spray your wood first, then let it dry, the engraving usually comes out a lot darker. It’ll be less likely to warp if you spray both sides. Because dithering dots are full-on or full-off and because human eyes are not, you have to pull the dark side down, and reduce the contrast a little, to get the middle ranges back. Hover over the image, right click and select ‘Adjust Image’.
0Reply
Relevant recommendations
- 2024-12-04
- 2022-11-29
- 2023-04-20
- 2023-07-31
- 2024-01-04