Getting a double image on the left side when engraving
Categories:
Laser
220
1
0
2023-08-04
Hello, I’m new here and new to laser engraving. I just bought the Atomstack A5 M40 and I’m getting a double/ghost image on the left side when engraving. I’ve adjusted the belts serval times, measured with a ruler and everything is even. Even uninstalled and reinstalled LightBurn and still getting the same outcome no matter what I do. Any suggestions on how I can fix this problem
C
David
2023-08-05I certainly can’t say for sure, but my first reaction would be: did you try reducing the speed? I’ve had similar problems with my A5 PRO Atomstack with small tight vectors running over 3000…3500mm/min or so. If not, then might be a problem with belt tightness … when adjusting your rollers & belts, and tilting the frame at a 45deg angle, the laser should, by gravity, slowly and consistently roll down the frame. If not, you have something too tightly set. If too fast, it’s too loose. Gotta get it right!
0Reply
Relevant recommendations
- 2022-09-05