Engrave text is shaky and out of line
Categories:
Laser
283
1
0
2023-08-10
Hello I hope someone can help me. The outline from the sublayer is out of balance. I did the same print yesterday and it looked fine.
Here’s what tried so far,
changed the lens
nozzle cleaned
x and y axis calibrated
all screws tightened
straps are tight
What else can I do? It’s getting worse!
The cut I made for calibration isn’t also straight after 3 calibration attempts. As you can see on the photo
I have a sculpfun S30 10 W
C
Cyril
2023-08-11This is almost certainly something mechanical. And it seems quite severe. I would think you should be actually able to see the extraneous motion visually. You may want to take some high speed video of the laser in motion to see if you can identify the source of the movement. If you do this, I suggest mounting the camera rigidly so you’re not adding motion from hand holding. I’d suggest first checking that the laser module is rigidly mounted to the gantry. Try manually manipulating the laser module in all directions. Do you feel any excess play? If so, identify the source of the play and try to eliminate it.
0Reply
Relevant recommendations
-
Alarm: 3 on anything but squares
1 Reply2023-07-21 - 2021-10-26