How to cut 10mm?
Categories:
Laser
295
1
0
2023-08-15
C
Miller
2023-08-16Perhaps you have LightBurn set for mm/sec rather than mm/min, in which case the laser will be moving 60 times too fast and won’t make much of a mark on anything. Or it can be set for in/min when you’re thinking mm/min, which will run only 25.4 times too fast. All those are in Edit → Settings. With that set properly, the next thing to check is focus, because a defocused beam has very little power. And then there’s the issue of assist air, without which the beam probably won’t penetrate through the smoke to the bottom of a 10 mm trench.
0Reply
Relevant recommendations
-
Offset Not Working Correctly
1 Reply2023-10-27 - 2024-01-04
- 2023-07-05
-
Missing Laser Spot
1 Reply2023-04-26