Reading a barcode into Lightburn
Categories:
Laser
296
1
0
2023-08-16
C
Nugent
2023-08-17There’s no direct facility for this. However, depending on your needs you could potentially scan and then write to a CSV file which could then be read in LightBurn. Or if the scanner could act as a keyboard you could potentially have it scan and enter text. I assume you’re trying to do this as some sort of automated process. Other than writing to a CSV I suspect this will be difficult in that case.
0Reply
Relevant recommendations
-
Não consigo cortar EVA Branco
1 Reply2023-11-22 - 2022-09-20
-
Device to use two laser CO2 tubes
0 Replies2023-06-08 - 2023-05-10