Print and Cut: Filled items now open after cutting
Categories:
Laser
128
1
0
2023-10-11
C
David
2023-10-12I think in spite of LightBurn showing the design shapes as filled, they are in fact open. You can check for this by going to Edit->Select open shapes. That will show you all the open shapes. This is easily remedied in this case by: 1. Select entire design 2. Edit->Close path Then retry the Cut Shapes operation.
0Reply
Relevant recommendations
-
Changing start point
1 Reply2023-11-06 -
Two designs filling twice
1 Reply2023-03-21