Z axis drop down setting
Categories:
Laser
27
1
0
2023-10-24
On my Atezr L2 with movable Z axis I am trying to make the laser head drop down .5mm per pass, is this the correct setting? or should I go to .75 or even a full mm?
Here is how I have it set now:
C
Cyril
2023-10-25"laser head drop down .5mm per pass, is this the correct setting?" Assuming that the machine functions in a typical way this should be correct. "or should I go to .75 or even a full mm?" This is more about your specific needs and the material to be cut so impossible to generalize. I’d suggest running some tests to see if there’s actually an improvement and to dial-in the best settings.
0Reply
Relevant recommendations
- 2022-09-14
- 2023-05-26
- 2023-02-28
- 2023-04-19