Cut issue in second pass
Categories:
Laser
37
1
0
2023-11-07
Does anyone have any idea why when I’m trying to cut the second pass it goes off the line?
Please look at the attached image:
C
Aaron
2023-11-08You have unaccounted motion in your laser mechanism. Eliminate any possible backlash. Do a full mechanical review: 1. pinion gears are properly secured to stepper shaft 2. all couplers properly secured 3. review belt tension 4. wheel tension 5. any other mechanical linkage
0Reply
Relevant recommendations
- 2023-07-07
-
Rotating image distortion
2 Replies11-05 - 2022-08-18
- 2022-08-01