Laser stops and Lightburn gives integer error
Categories:
Laser
97
1
0
2023-11-24
C
Williams
2023-11-25"a line in the GRBL code needing to be an integer" There’s nothing wrong with the G-Code, so this is almost certainly a USB glitch that’s very hard to track down. Changing to a known-good / high-quality USB cable sometimes helps; ones with ferrite slugs on each end may have a higher likelihood of improving the situation. If there’s a USB hub involved, eliminate it and run the cable directly from PC to laser controller. If there’s a USB extension cable involved, it must be an active cable, not a simple extension. If at all possible, use a single good cable. USB 3 ports seem to work better, except when they don’t work at all. Fiddling with settings / drivers / configurations / whatever will not change the situation and will cause more problems by confusing the symptoms.
0Reply
Relevant recommendations
- 2022-09-21
-
Lightburn and Linux Mint XFCE all good!
2 Replies2023-05-30 - 2022-08-16
- 2023-05-23