Join two lines to make one but without group?
Categories:
Laser
136
1
0
2024-01-08
C
Henry
2024-01-09"join A to B to make one line without using group" Basically, you can’t. By definition, a path consists of vectors joined by nodes. Each node sits between at most two vectors, so you cannot have a T intersection with three vectors meeting at a node. What you can do is use the Node Editor to trim the vertical line where it meets the horizontal line. Then you group the two lines into a single unit that you can move around as needed.
0Reply
Relevant recommendations
- 2022-10-17
-
"New Window" of Car Lidar Track
0 Replies2023-01-09