English

Zero degree carving, but there is an angle when it comes out

37
1
See translation
2024-10-09
We are setting up a laser machine to carve copper; From the first test, for example, by digging a small square at 0 degrees, a Z-dip angle of approximately 10-15 degrees can be obtained. What parameters should we use for perfect straight line cutting?
C
    • Payson

      2024-10-10
      It's simple, you have to do chip removal like drilling a hole, enter one or two millimeters, and then completely come out to crush chips or remove dust. If you are drilling a hole to press resin, use a laser to do the same thing to close it and blow away the waste until the end of the hole.
      The difficult part is getting everything done right
        See translation
        Reply
      Collect
      Report