chanelink logo
CHANELINK
English

Randomization of material testing sequence

Categories:
Laser
3
1
See translation
10-16
Is there any way to randomise the order of the shapes burned in the material test? The localised heat effects of ramping power/frequency/speed in the x axis tend to give unreproducible results when these are taken into consideration. I have tried putting a 0% sublayer in to reduce this, but it makes the time to run a test significantly longer.
Stainless steel and Titanium especially so.
Essentially, I want the antithesis of optimise settings. Give me the biggest distance possible between material test squares!
C

    • Payson

      10-17
      There is not, no.
It always burns “coolest to hottest” because on diode or dsp lasers if the range is going to end up “too hot” we want it to get there last, so you can stop it as soon as a cut goes through.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report