The curve is not good. Why is that?
Categories:
Laser
154
2
0
2024-11-18
C
Clarence
2024-11-19If you rotate the art 90 degrees in LightBurn and resend the job does the behavior move? There are a few things that can cause this. Did you draw these using arc and circle drawing tools in LightBurn or are these files from a vendor. The right leg of the mouse has a finer sawtooth shape than the pillow. This leads me to believe that it is not exclusively in the belt drive system or exclusively machine harmonics/vibration. Short line segments may be starting and stopping the engraver, causing this behavior.
0Reply-
: Sorry for the delay. I lowered the speed to 12 mm/second and got much better results. It seems my Chinese laser cannot cut well with 20+ mm/second. It’s a pity to cut 4mm plywood at 12mm speed
-
Relevant recommendations
-
plate rolling machine factory
1 Reply02-12 - 2023-05-25
-
Filled area to dxf problem
1 Reply2023-03-18 -
LightBurn won’t turn on the laser
0 Replies2023-08-08 - 2022-05-30