Laser machine replacement and debugging guide

Preparation work before replacing laser machine parts
Before replacing laser machine components, it is necessary to first turn off the machine power and confirm the model and parameters of the components to be replaced. At the same time, suitable tools such as electrician pliers, screwdrivers, focusing cards, etc. should be prepared.

Replace laser machine components
1. Open the laser equipment and locate the component that needs to be replaced.
2. Use appropriate tools to disassemble the original components, taking care not to damage the surrounding parts.
3. Install the new component in the corresponding position and secure the screws.
4. Adjust the corresponding parameters based on the model and parameters of the new component. For example, adjustments can be made by adjusting parameters such as laser power, frequency, and focus.

Laser machine debugging
After replacing the laser machine components, relevant debugging work needs to be carried out, including adjusting laser power, image quality, focusing and other parameters to achieve suitable laser processing effects. The specific steps are as follows:
1. Turn on the power of the laser machine and wait for heating. Aim the laser at the processing object and focus it.
2. Adjust the laser power, press the laser switch, observe the laser processing effect, adjust the laser power, and ensure that the laser processing effect reaches the best state.
3. Adjust the laser image quality by adjusting parameters such as the size and spot quality of the laser beam to make the processing results more precise and uniform.
4. Check the laser head, lens, and other parts to ensure that there are no looseness, dirt, or other issues.

Frequently Asked Questions and Answers
Why is the usage time getting shorter and shorter after replacing the laser?
Answer: It may be that the mirror needs to be cleaned or the laser does not dissipate heat well.
What should I do if there is bubbling during laser processing?
Answer: It may be due to the power not being set properly or the focal length not being appropriate.
How to adjust the blurring in laser processing?
Answer: It can be adjusted by adjusting parameters such as focusing or laser spot size to achieve better processing results.