Detailed explanation of replacement method for laser cutting machine slider

Preparation work for replacement
Before replacing the slider, it is necessary to prepare the corresponding tools and spare sliders to ensure timely completion of the replacement process. Meanwhile, in order to prevent accidents, the laser cutting machine needs to be powered off and put on standby for a period of time.

Use tools to remove the original slider
Use a Phillips screwdriver to remove the screws that install the slider, then gently remove the original slider from the laser cutting machine and clean the residue of the original slider to avoid interference with subsequent replacement work.

Install a new slider
Insert the spare slider into the guide rail on the laser cutting machine in the corresponding direction, paying attention to aligning the position. After confirming that the installation is correct, slowly tighten the screw back to its original position.

Adjust the angle
After installing the new slider, it is necessary to adjust the angle to ensure that the laser cutting machine can operate normally. You can operate according to the instructions provided by the manufacturer.

Test validation
After the slider replacement is completed, it is necessary to turn on the machine to test the cutting effect and verify whether the laser cutting machine can work properly. If any abnormal situation is found, it needs to be dealt with in a timely manner.

matters needing attention:
1. Before replacing the slider, power off and wait for a period of time;
2. When replacing the slider, use a Phillips screwdriver to remove the screw and be careful not to overtighten it;
3. When replacing the slider, ensure that the slider is inserted in the correct direction, aligned in position, and then fixed;
4. After replacing the slider, it is necessary to adjust the angle to ensure the normal operation of the laser cutting machine;
5. After replacing the slider, it is necessary to conduct a test to verify whether the cutting effect is normal.