chanelink logo
CHANELINK
English

I want to change the+Y axis to - Y and the - Y axis to+Y

Categories:
Laser
44
1
See translation
03-21

I have an Atomstack A24 Ultra 24v diode laser using GLBR-LPC controller and running Lightburn version 1.7.06 on Windows 10 laptop. This configuration works fine with no issues. My working area is 365mm x 305mm (X and Y).
I have just purchased an Atomstack R5 Conveyor Feeder to extend my work height from 305mm to 800mm on the Y axis. So far, my only issue is any command from given to the laser moves the conveyor table in the wrong Y direction.
Is there anyway in Lightburn to switch the direction of the Y axis?

Additional information about the setup: The A24 Ultra has a Y-axis Switch to change between Normal and Accessory mode. When the switch is set to Accessory mode, the Laser head moves to the center of the normal Y direction travel and is locked. The bed moves back and forth when any Y command is sent to the laser. The A24Ultra laser head only moves in the X direction.
C

    • Miller

      03-24
      I believe if you go the the Edit Menu> Machine settings there is an option to invert the Axes individually. Always back up the settings beforehand in case you mess things up.
You will need to scroll to the bottom of the screen and click Outputs Setup, then a confirmation that you want to.
        See translation
        Reply
      Relevant recommendations
      Collect
      Report