When operating RDC6442S, an error occurred after the automatic blocking of the graphic super format was selected.

Vasili

Categories:

Ruida

Tags:

Ruida
RDC6442S

180

See translation

2022-11-21

When the RDC6442S is operated, the graphics super format is automatically divided. The laser first cuts in the X direction and then does not emit light. The U axis starts to feed materials to a certain length, and then the laser cutting stops. (Automatic blocking does not work)

Keegan

2022-11-26

The laser head must be stopped at the bottom of the Y-axis direction (the end close to the person) because the operation position of the laser head is not correct.

See translation

Relevant recommendations

Collect

Report

When operating RDC6442S, an error occurred after the automatic blocking of the graphic super format was selected.

Using V8 software, in user parameters, cutting parameters and idle acceleration are invalid after they are changed,how to solve?

Switch to the manual state, press the Z+and Z - buttons on the operation panel, and the Z-axis motor will not move

Controller/lightburn/manfiele rotary problem

Need suggestions on replacing my torched homebuilt Frankenstein.

When pressing Z - or Z+for a longer time (about 3-4S), the Z axis will go down or up all the time, and it is normal to press Z - or Z+for a shorter time.