The border running is normal, but the click to start does not respond.

Gilbert

Categories:

Ruida

Tags:

Ruida

166

See translation

2023-01-06

The border running is normal, but the click to start does not respond.

Smith

2023-01-09

① The lower right corner of the main interface of the inspection panel should be set to offline mode;
② If it is a single head machine, enter "File" - "System Setting" - "Manufacturer Parameters", check the number of cutter heads, and set it correctly to 1.

See translation

Relevant recommendations

Collect

Report

The border running is normal, but the click to start does not respond.

It is useless to set a fixed point, no matter how many times you set a fixed point, or start cutting from the same position.

Vibrating knife cutting pattern is not closed.

Ghost appears in scanning

It is always impossible to cut through. Finally, it has to be cut twice, and the effect is not good. How to adjust it?

When pressing Z - or Z+for a longer time (about 3-4S), the Z axis will go down or up all the time, and it is normal to press Z - or Z+for a shorter time.