Problem when filling a figure (undulations)
Categories:
Laser
237
1
0
2023-02-21
I have recently bought my new laser engraving Ortur Laser Master 2 s2. Testing the machine I found this problem:
As can be seen, there is a kind of undulations within each figure, regardless of the speed of movement, they always appear.
I hope someone can help me identify the problem.
Thank you
C
David
2023-02-22I’d guess some sort of modulation of the laser power. The top two look like the same pattern , so I’d be interested to know if it was power or speed that changed between them. I’d also be interested to know if the material was moved between burns, because that could help prove or disprove Colin’s flat spot suggestion. (They’re slightly offset in x - a flat spot would have stayed x aligned). If the laser power isn’t steady I’d guess the culprit is the PSU, but it could also be the emitter.
0Reply
Relevant recommendations
- 2023-08-15
-
Four way arrow gone missing
2 Replies2023-05-15 -
Joining Paths and Circles
1 Reply2023-04-20