chanelink logo
CHANELINK
Deutsch

Not Marking

Kategorien:
Laser
Tags:
278
1
Übersetzung anzeigen
2023-02-24

I have MP-30 LiteMarker 30W Split Laser Engraver… I have EZCAD 2 and have installed the driver just fine. I have adjusted the focus. I have used the EZCAD 2 that was shipped with the laser.
C

    • Payson

      2023-02-27
      1. Check if all buttons are turned on
2. Check whether the driver is connected correctly
3. Check parameter settings, output or fill
4. Turn the rotary wheel up and down to check whether there is laser emission
        Übersetzung anzeigen
        Antworten
      Relevante Empfehlungen
      Sammeln
      Report