chanelink logo
CHANELINK
Ελληνικά

RDC6563FG

Κατηγορίες:
睿达
405
7
Δείτε τη μετάφραση
2023-07-19

I have an Ruida RDC6563FG laser controller controlling a Max laser.

 

If I manually open the Max laser shutter off the Ruida control panel the shutter opens and the laser fires correctly.

 

But when I create a program using RDCUTIST, the program runs through its sequence, but the laser shutter does not open.

 

Any help would be appreciated. 
C

    • Pavel_TT

      2023-07-20
      Hello.
I have a 6563fg and a ruci laser source.
I set up shutter and everything works.
I have a "laser" connector, the pinout is different from the manual.
The shutter pin is on Pin6.
pin11 - +24V.
pin6 - shutter.
        Δείτε τη μετάφραση
        Απάντηση
        • Pavel_TT

          : here is my connection

        • Pavel_TT

          : pin6 - shutter pin10 - analog 0-10v pin11 - +24v (REM) pin12 - mod pin15 - GND

      • Cityslicker

        2023-11-17
        Thank you Pavel I have altered the wiring as per your instructions and the laser will manually fire and the shutter control is correct now. But the still the laser does not fire when running a program. The Rdcutist software isn’t licensed ? Do I need to activate it to get it to work.
        Δείτε τη μετάφραση
        Απάντηση
        • Sarva

          : i've same problem laser cannot enabled, help me please

        • Sarva
          Απάντηση
          @Sarva

          : here is my wiring diagram on RAYCUS

        • Sarva
          Απάντηση
          @Sarva

          : this is from ruida RDC6563FG

      Σχετικές συστάσεις
      Συλλογή
      Αναφορά