chanelink logo
CHANELINK
Ελληνικά

Creality Falcon 2 - Factory Reset

Κατηγορίες:
Λέιζερ
Ετικέτες:
109
1
Δείτε τη μετάφραση
2023-12-06

I’m wanting to reset my Falcon 2 to factory default. I am getting the following error: G-code motion target exceeds machine travel. Worked before playing with rotary. Would like to default Laser and Lightburn software.
C

    • Vasili

      2023-12-07
      It’s very common to inadvertently leave rotary enabled.
On your LightBurn screen please confirm that there’s no green dot next to the Rotary Setup icon near the top Row and there are no words in the bottom corner that say ‘Rotary Enabled’.
If they’re there, click on the Rotary Setup icon and switch off ‘Enable Rotary’ then click OK and confirm that the green dot and Rotary Enable text are both gone.
If that’s not it, we’ll try the next thing.
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά