chanelink logo
CHANELINK
Ελληνικά

Unable to cut all materials

Κατηγορίες:
Λέιζερ
Ετικέτες:
148
4
Δείτε τη μετάφραση
03-07
Never used a laser before, I’m trying to make lamacoids with a K40+, but I can’t seem to get the settings dialed in. It leaves some of the material behind… Been trying for 2 days now!
The good looking one is my sample, that what I want it to look like. I have the manual power dial set to about 50%.
laser
laser
laser
 
C

    • Ferall Raj Patel

      03-11
      What kind of equipment do you use?
        Δείτε τη μετάφραση
        Απάντηση

      • Abel

        03-17
        Are you set to OFFSET fill? It looks like it from the photo. Set to FILL mode and try again.
          Δείτε τη μετάφραση
          Απάντηση

        • Payson

          03-18
          Hi, I used to do hundreds of lamacoids for a customer that I had. He would send me a Excel spreadsheet that I would import into AutoCad, save as .dxf and then import it for engraving/cutting.

The top layer of the lamacoid is very thin (.003"). You need to take very little off. At the time, I was using a CO2 60 watt machine and my settings were approximately 800mm/s and power was around 35%.

I think you are going a little too slow. Try increasing the speed and power and see if your results are and better.

Also, I used WD40 to clean the lamacoid. Worked amazing.
            Δείτε τη μετάφραση
            Απάντηση
            • Rajiv001

              : Hey Payson, Thanks for the tip, we assumed that we were going too fast and that’s why it was missing bits. The max speed on K40+ is 300 mm/s so I changed it to that and put power to 22.5%. We were originally testing on the fill setting, but because we were going too slow it was burning passed the edge and giving us wobbly letters. Final settings were: 1 pass, 300 mm/s, 0.03 mm interval, 22.5% power on Fill

          Σχετικές συστάσεις
          Συλλογή
          Αναφορά