Español

Walt530 ( project won’t center)

Categorías:
Láser
Etiquetas:
363
1
Ver traducción
2023-03-22

Project won’t center when I engrave, it was fine two days ago but not today, Help

C
    • jessie

      2023-03-23
      Are you ever moving the head of the laser by hand after homing? If so, this is likely the cause of the issue as your machine will no longer have correct knowledge of position.
      If you’re not moving it by hand then can you provide the following:
      1. Overview of your workflow and what you’re doing.
      2. Full screenshot of LightBurn with your design loaded and ready to burn. Please have Cut and Laser windows showing.
      
        Ver traducción
        Responder
      Recoger
      Informe