Why only the bottom half of the design is engraved?
Categorías:
Láser
272
1
0
2023-04-01
C
Miller
2023-04-03The Tabs/Bridges being enabled is likely cutting off the portions of the layer that you’re saying are getting removed. Disable that.
0Responder
Recomendaciones relevantes
-
Fill Shapes Individually Not working Galvo
1 Respuesta2023-11-10 -
Atomstack MR20 issues
1 Respuesta2023-11-06 -
Missing Laser Spot
1 Respuesta2023-04-26 -
Ikier laser power loss
1 Respuesta2023-08-22 -
How do I prevent this attack?
1 Respuesta2023-09-25