chanelink logo
CHANELINK
Français

My SCULPFun S30 5W laser is experiencing issues

Catégories:
Laser
129
5
Voir la traduction
01-07
Since the Lightburn update, I have encountered issues and realized that the settings for speed and power have changed, and my machine is no longer functioning properly. For more information, I am using SCULPFUN S30 5W, but this time I encountered difficulties at work because. I no longer find myself asking for help because my problem has not been resolved so far. I also want to know if you offer courses because there are some elements that I want to learn and understand.
Looking forward to a good outcome
C

    • LI

      01-07
      hello
        Voir la traduction
        Répondre

      • Aaron

        01-08
        The first thing I’d try is to re-load settings from a date you know it worked. This can be done using the show preferences folder and reload an old configuration. Next would be to re-install LightBurn. This helps in most cases.
You can also try to reset the firmware settings in the laser by sending $RST=* via console.
          Voir la traduction
          Répondre
          • Carey

            : Thank you very much for taking a break, but please see, I will send a capture so that you can understand, because even with the old version I installed on 1.6.03, the speed and power are still the same, and although I tested with the old grid file, there is no change. I will send a capture so that you can see what I am saying

          • Carey
            Répondre
            @Carey

            : Thank you, I have resolved the issue by carefully reading your message and solved the problem

          • Aaron
            Répondre
            @Carey

            : Great. You have set LB to mm/s as units in your screenshot, you should set it to mm/min. Then you can compare your settings to everyone else using diode lasers. But I guess you already did this then.

        Recommandations pertinentes
        Collecter
        Rapport