chanelink logo
CHANELINK
Français

Origin readings Y-390 and X-279

Catégories:
Laser
Tags:
102
5
Voir la traduction
03-03
I have a Fox Alien Vasto CNC. The machine homes to the bottom left corner and in light burn it puts the laser in Y -390 and X -279. I have no problem burning or cutting projects because I align my projects with the laser off of the work area and it runs fine. But I have added a camera to help me align projects and when I try and align the camera it puts the graphics to burn to help align the camera in side the work area and when I run the program it sends the machine right into the limit switch’s. Can you adjust the work area to where the machine homes?
laser
C

    • John Trant

      03-04
      Try enabling CNC mode
      Voir la traduction
      Répondre
      • LWE

        : thank you for replying. I turned on cnc and it put the origin just the opposite in the positive. If I change the origin between top right and bottom left the laser position does just the opposite.

    • Keegan

      03-06
      Enter G10 L2 P1 X-279 Y-390 in the Console window. This should tell your machine to operate in the first quadrant, which is where Lightburn is happy.
      Voir la traduction
      Répondre
      • LWE

        : Thank you for your help. I’m a little new to this so bare with me, when you say console window you mean in light burn where you type commands?

      • Keegan
        Répondre
        @LWE

        : That is correct.

    Recommandations pertinentes
    Collecter
    Rapport