XY axis cannot be limited
Catégories:
Ruida
248
1
0
2022-12-12
C
Miller
2022-12-13Analysis and troubleshooting: ① If the reset moves in the opposite direction, the "reverse polarity" is set incorrectly. ② The incorrect setting of "limit polarity" causes that the limit cannot be detected when the system is reset, which leads to shaft collision. ③ The format is too large. ④ Steps vary widely. Solution: Correct the direction signal polarity, limit polarity, format and step distance corresponding to the axis.
0Répondre
Recommandations pertinentes
- 04-08
- 2022-12-07
- 2024-11-23
- 2023-01-09