chanelink logo
CHANELINK
Italiano

Fiber frequency settings

Categorie:
Laser
Tag:
335
1
Vedi traduzione
2023-04-20

Is anyone aware of a good description of the relationship between power, speed, and frequency? especially frequency. I am having trouble dialing in my settings mostly because I just don’t know what to change when something is not working. For example, I CANNOT get my settings right on powder-coated tumblers. It’s either too deep and cutting into the metal or not enough to remove the powder coat. I feel like I’m just going in circles because of the three settings that can be changed. I think if I understood better the relationship among the three, I would be better able to problem solve. thanks in advance!
C

    • Keegan

      2023-04-21
      The best way to think about frequency is to think of it like sandpaper. If you have 20 grit sandpaper, it’s got big rough sand particles on it. If you have 200 grit sandpaper, it’s smoother. Same with frequency. 20 kHz frequency will be a lot more aggressive than 200 kHz frequency will be.

Powder Coated Tumblers are one of the worst on fiber lasers, as each and every color from each and every manufacturer will likely have a little bit different settings. Can ruin a lot of cups trying to get every variation dialed in. co2 laser is much better suited for powder coated tumblers in the end.
        Vedi traduzione
        Rispondi
      Raccomandazioni pertinenti
      Raccogli
      Segnala