My SCULPFun S30 5W laser is experiencing issues

hello

The first thing I’d try is to re-load settings from a date you know it worked. This can be done using the show preferences folder and reload an old configuration. Next would be to re-install LightBurn. This helps in most cases.
You can also try to reset the firmware settings in the laser by sending $RST=* via console.

• Carey

  : Thank you very much for taking a break, but please see, I will send a capture so that you can understand, because even with the old version I installed on 1.6.03, the speed and power are still the same, and although I tested with the old grid file, there is no change. I will send a capture so that you can see what I am saying
• Carey

  返信

  @Carey

  : Thank you, I have resolved the issue by carefully reading your message and solved the problem

• Aaron

  返信

  @Carey

  : Great. You have set LB to mm/s as units in your screenshot, you should set it to mm/min. Then you can compare your settings to everyone else using diode lasers. But I guess you already did this then.