Issue with Engraving Text in Correct Order

Dear all,

I am experiencing an issue when engraving text using RDWorks. Specifically, when I engrave multiple sentences, the machine does not engrave the text in the correct order. Instead, it seems to engrave partial letters from each sentence at once, followed by the remaining letters individually.

I have tried adjusting various settings, including scan modes and layer orders, but the problem persists. Could you please advise on the following:

1. How to ensure the machine engraves text in the correct sequence, letter by letter, from left to right (or in the intended order)?

2. Are there specific settings in RDWorks that I should adjust to solve this issue?

3. Is there an option to change the engraving order or path settings to avoid this fragmented engraving pattern?

Any guidance or troubleshooting steps would be greatly appreciated. Thank you in advance for your support