Has anyone encountered this problem and how did they solve it?
2023-08-2824410What is the matching power of the laser water cooler?
2023-08-2837910Which is the best choice for water-cooled, air-cooled handheld laser welding or dual circuit refrigerant direct cooled handheld laser welding?
2023-08-2839710I have traced a descent sized image in terms of L x W, so that the Trace Image feature can grab as much detail as it can.When scaling down the traced image, part of the trace disappears and there is a disconnect which can only be seen in the preview tab.Image preview when making the trace bigger and there is no disconnect:How can I make sure th...
2023-08-2523010No matter how large I make the ‘Y Center’ or ‘X Center’, the generator keeps this tiny space between the cuts squares. Take a look at the screenshot. I need that gap to be larger otherwise the laser just cuts into the next line.
2023-08-2532710HII would like to understand why the preview of the photos almost never corresponds to the final result.Show the photo always much darker and therefore you are forced to experiment, wasting a lot of time and material consumption.Solutions?
2023-08-2432310Most precision stepper motor applications — especially those in automation and motion control — use a control method referred to as microstepping, which creates a sinusoidal (or nearly sinusoidal) current waveform, rather than the square wave of current produced with typical full-step control.The current rating of a stepper moto...
2023-08-2435910I have an IKIER K1 Pro connected to Lightburn 1.4.00 via the grbl-lpc driver.The idle speed is very slow and I would like to increase it. How do I do it?
2023-08-2534410New getting Missed Steps. Got a hold down magnet (quite powerful) on Stepper Motor, and also gantry obstructed on home.The belts are OK, steps only Y mainly I think…Could there be missing teeth - does not always occur.Are there settings that I could change to helpLawrence
2023-08-2524410This is my question: I’m drawing in inkscape paths in differents colors. The closed path can be rustered, so the question is: can engrave grayscale background with “proportional power” like image engrave function?
2023-08-2535110I am just starting to use Lightburn software and it is not as friendly as it seems when I watch the hours for videos.I am trying to cut the corner off of a piece of wood.I just the pencil to draw a straight line then use the same settings as I did with a rectangle key chain.But, the laser just lightly scores the wood and will not slow and cut.What...
2023-08-1741110Hello what is the best configuration to record in glass with ink, stanley cups or similar, thermal cups, I want to know what is the best configuration using EZCAD SOFTWARE, to record in stainless steel cups with ink, someone can help me???
2023-08-1238520Im getting a noticeable wobble in my x axis?I’m a bit lost on what to do since the belt is pretty tight already.
2023-08-1440710I was cutting and engraving 1/8 ply when my settings changed from 90/20 to .3/55. Cutting and engraving speeds are all less than 10mm/s. I have reloaded the cut library and redownloaded one as well. Still nothing. It changed all of the settings in the library with speeds starting 0.xxx. Any advice is appreciated.
2023-08-1141010
- 데이터 없음
한국어
- English
- 简体中文
- 繁体中文
- Français
- Русский
- Italiano
- 日本語
- 한국어
- Português
- Deutsch
- Español
- Türkçe
- Ελληνικά
- Nederlands
- Tiếng Việt
- Polski