chanelink logo
CHANELINK
한국어

Alarm: 3 on anything but squares

카테고리:
원자 램프
태그:
216
1
번역 보기
2023-07-20

Hey i have gotten a new laser. a Monport 40w.

it cuts just fine when i sett up a test square, but if i try adding a picture or even just a circle i get this error.

ALARM:3
Reset while in motion. Grbl cannot guarantee position. Lost steps are likely. Re-homing is highly recommended.
On or near line 23:
Job halted
Stream completed in 0:04
sys.aborts
MonPort
Grbl 1.1f [‘$’ for help]

ive used lightburn on a different laser up until now and never had this error before.
C

    • Aaron

      2023-07-21
      ALARM:3
Reset while in motion.

Alarm 3 says the E-stop button was hit. I doubt you leaned on it while the machine was running. Does it stop in the same place every time or is the “on or near line” different each time? If it appears random, I would suspect a loose terminal connection on the E-stop button, or at the Controller board.
        번역 보기
        답글
      관련 추천 사항
      수집
      보고서