chanelink logo
CHANELINK
한국어

The starting and ending positions are different

카테고리:
원자 램프
태그:
159
3
번역 보기
2024-10-11
So when I engrave or cut the laser moves to the same position it starts from. When I use the rotary and engrave tumblers the laser head goes to a differant position from where it starts. This has changed since I upgraded from 1.6 to 1.7.01. How do I change so laser head parks after engraving in the same position it starts?
C

    • Cyril

      2024-10-12
      Check if you have this option selected.
      번역 보기
      답글
      • Noah

        : not sure if return to finish should be checked or not… I have always used " Currant position"

      • Cyril
        답글
        @Noah

        : You need to select “Return to Finish Position” if you intend to park the laser head in a certain location. That location is set below on “X” and “Y”

    관련 추천 사항
    수집
    보고서