I am looking for help with my Ruida 6445G Controller. The problem is the Z Axis. I have tried multiple options. Trying to get the Z Axis to show me in mm the actual length is not happening. For 100mm on the Controller is only about 4mm movement. I tried using the Auto calculations of Entering this information and the stepper was set at 0.2 which th...
2023-01-30300112When RDC6563F is used, XY axis does not move manually.
2023-01-0344430I power laser on and it only displays connecting to controller. I have disconnected the him from the controller and nothing homes. I have led 15 and 12 lit up with eithernet discounted. Homing switches work chiller input works and all drives are good no faults. Any ideas?
2023-02-0233120Can sombody help me whit software Vcutwork ?After changing the mainboard i can't put the right parameters back before.I don't have backup .?The milling cutter and the knievs don't take the rise that i set from keyboard and they allways get up in the hom position to make the jump and i loos too much time in this mode .I need to know how can...
2023-02-0827021Once powered on, the cutting head will always move upward, and will not stop. Switch to the manual state, and the motor can be controlled to move, and then switch to the automatic mode, and always move upward.
2023-01-1034510The cutting head does not lift up and down, but the motor has sound.
2023-01-1019610After normal connection, press the auto-focus button, and the cutting head will move upward all the time.
2023-01-1023310After cutting, it is found that the graphics in the software and the actual graphics are reversed from left to right or up to down.
2023-01-09283106563F moves manually on the panel according to Z-axis, and the cutting head does not move.
2023-01-0539120The processing serial number arrangement is invalid.
2023-01-0522210Just installed ruida 6442 and control is always reseting 10000mm x 10000mm y and I can't figure it out for the life of me
2022-12-2834510It is always impossible to cut through. Finally, it has to be cut twice, and the effect is not good. How to adjust it?
2023-01-0931810It is useless to set a fixed point, no matter how many times you set a fixed point, or start cutting from the same position.
2023-01-0625610The border running is normal, but the click to start does not respond.
2023-01-0625410
- Geen gegevens
Nederlands
- English
- 简体中文
- 繁体中文
- Français
- Русский
- Italiano
- 日本語
- 한국어
- Português
- Deutsch
- Español
- Türkçe
- Ελληνικά
- Nederlands
- Tiếng Việt
- Polski
