chanelink logo
CHANELINK
Nederlands

Tracing whole image

Categorieën:
Laser
Tags:
110
1
Bekijk vertaling
2023-10-14

I have been reviewing all of the posts on this site for image tracing but not able to figure out the issue I am having… I would like to put this image on a glass, without the black backgrounds (once you convert it in Lightburn)
but each time I try to trace it and take out the black backround parts of the feathers also disappear. I took it into an image editor and tried to remove the blacks but that did not work well.

LightBurn
C

    • Christian

      2023-10-16
      You can trace the same image multiple times using different settings to capture different areas. Zoom in, pan around, and fade the image to see the trace lines better. Adjust slider to capture the desired areas. The “ingore smaller than” setting is also extremely useful to minimize stray “noise”.

Remember, a trace is just an OUTLINE. A line between the white and black is both the inside of one and outside of the other.
        Bekijk vertaling
        Antwoord
      Relevante aanbevelingen
      Verzamel
      Rapporteren