Join two lines to make one but without group?
Categorieën:
Laser
272
1
0
2024-01-08
C
Henry
2024-01-09"join A to B to make one line without using group" Basically, you can’t. By definition, a path consists of vectors joined by nodes. Each node sits between at most two vectors, so you cannot have a T intersection with three vectors meeting at a node. What you can do is use the Node Editor to trim the vertical line where it meets the horizontal line. Then you group the two lines into a single unit that you can move around as needed.
0Antwoord
Relevante aanbevelingen
-
Latitool f50 not working with lightburn
1 Antwoord2023-04-23 -
Virtual Camera Set Up
1 Antwoord2023-04-15 - 2023-09-13
- 2024-03-19
-
Ray5 10W Laser Speed?
1 Antwoord2023-05-23