When user use RDC6442G or RDC6442S to do a cutting and engraving, different auxiliary gas pressure should be set according to engraving and cutting . usually engraving should set a low pressure auxiliary gas and cutting should set a strong gas .For RDC6442 series， there is only a port named <wind> to control auxiliary gas. here is a ex...
2022-01-2428702Description of the auto-focus functionThere are 2 options for the auto-focus function in RD controllers. See the picture below.  ...
2021-11-2925700RD Controllers has USB and Ethernet port for data sending. For some cases, if the USB port is burnt out, User can try the Ethernet port to make the controller working. user can follow the steps to set up a Ethernet connection with RD controllers.1 Prepare a Ethernet cable and make sure the cable can do a correct internet connection.2 Connect the ca...
2021-10-2924200RDC6445G and RDC6445G has the same function and the performance!The only difference is the operating panel; the dimension of operating panel is different. that has more option for machine manufactures to install the panel because of the different dimension of the machinebut here should be noticed:The update firmware of the operating is differ...
2021-10-2927800"Usually user does a job with many hatch vectors, the vectors are not alignment when finished the cutting. look the picture below:here we can see there are some vectors is out of the contour of the shape. but the correct cutting result is like the below:the cutting error is caused by the motor's responsibility and the controller. if the motor respo...
2021-10-2624700
- Brak danych
Polski
- English
- 简体中文
- 繁体中文
- Français
- Русский
- Italiano
- 日本語
- 한국어
- Português
- Deutsch
- Español
- Türkçe
- Ελληνικά
- Nederlands
- Tiếng Việt
- Polski